Surfacing

PP-Np-30H5G2SM (Np-30Cr5Mn2SiMo)

Flux-cored wire for automatic and semi-automatic open-arc, submerged-arc or gas-shielded hardfacing of parts exposed to metal-to-metal friction with extra alternating and impact loads.

Order form

Additional Information

Diameter, mm	1.2 - 4.0
Curent type / Shielding	DC+ / open arc, flux, Ar, СО₂, Ar + CO₂
Working conditions	Metal-to-metal friction with extra alternating and impact loads
Applications	Hardfacing of tracked vehicle undercarriage sprockets and rollers, rubber mixer chambers and augers, etc.

Weld formation	good
Slag separation	good
Deposit factor, g/A·h	10 - 15
Crack susceptibility	moderate
Wire consumption per, kg	1.05 - 1.2
Hardness (3-layer deposit on mild steel)	HRC 48 - 56

OPERATING CONDITIONS (open arc)

Wire diameter, mm	Current, A	Voltage, V	Deposition rate, m/h	Wire stick-out, mm
1.6	160 – 220	24 – 26	10 – 14	30 – 40
2.0	200 – 250	25 – 27	12 – 17	30 – 40
2.4	240 – 290	26 – 28	15 – 19	30 – 40
2.8	260 – 350	26 – 28	18 – 22	30 – 40

Download

Similar products

PP-Np-100H

Flux-cored wire for automatic and semi-automatic open-arc or gas-shielded hardfacing of parts exposed to high impact loads and severe abrasive wear at normal or sub-zero temperatures.

Hardsteel 59A

Flux-cored wire for automatic and semi-automatic gas-shielded hardfacing of chromium carbide-hardened martensitic steel pad on the surface of parts exposed to severe abrasive wear and relatively high impact loads.

PP-Np-90G13N4(PP-AN105)

Flux-cored wire for automatic and semi-automatic open arc hardfacing of wear-resistant pads on parts subject to heavy impacts.

PP-Np-15

Hardfacing and repair of damaged parts exposed to heavy contact loads.

Hardsteel 54

Flux-cored wire for automatic and semi-automatic open-arc hardfacing of carbon or low-alloy steel parts exposed to metal-to-metal friction, alternating and impact loads at normal and increased temperatures.

Hardsteel 45

Flux-cored wire for automatic and semi-automatic open-arc, submerged-arc or gas-shielded hardfacing of steel mill rolls exposed to metal-to-metal friction, cyclic thermal load and corrosion.